Recent content by muchacho

Yes, I confirm, even 192/24 tracks play almost instantly!!! Good job WiiM!!! THANK YOU!!! ;-)

Hi, I have a question for you, can I send you a direct message somehow? I guess you don't have it enabled... ;-)

Hi, I did the testing. Tidal playback on mobile: after skipping to the next track, playback starts immediately, both 44.1/16 and 192/24. Playback via TIDAL Connect in WiiM Pro Plus is the time between skipping a track and starting playback for 44.1/16 4-5 seconds and for 192/24 10 or more...

I can confirm, it also takes a while for the next track to load and start playing after switching when listening via TIDAL Conect. I have a feeling it has to do with the constant improvement and addition of streamer features and therefore more CPU load. But could I be wrong...? Skipping was...

I still realized that I have experience with measuring with IK Multimedia ARC 4 and then saving the curve in the ARC Studio hardware box. In this case, there is the possibility of a simple measurement in seven positions, or a full measurement in the same seven positions, but in total three...

I have a Neumann 2* KH150 + 1*KH750 setup in my main basement listening room and the MA1 room alignment system requires 7 measurement positions plus for each speaker separately including the subwoofer. By the way, the first time I used it, I entered the production number of the MA1 measuring...

...but with a .cal calibration file, the measurement would theoretically be even more accurate...! ;-)

I had the set range according to the speaker system manufacturer 35 - 20000 Hz (+-3dB)

Thank you, but it's just that it's not very acoustically adjusted! There are some shelves, some cupboards, a corner sofa, a piece of carpet and most importantly a large window. The natural reverberation is quite large, but the WiiM RC helps quite a bit. It is with the help of the calibration...

The first measurement is from the built-in microphone of the Galaxy S10, the second IMM-6 and the third IMM-6C. The first is different, but the second and third measurements are somewhat similar. Measured in the same position.

Like this, first of all I only have Pro Plus. I took the measurements in the same location, with the Dayton Audio microphones mounted on a tripod. There certainly won't be much difference between the individual pieces, but for my own good feeling I would like to use them with the calibration...

I REALLY want .cal file support for my Dayton Audio IMM-6 and IMM-6C external microphones. I feel that when I do something, I try to do it as well as possible, or at least have that feeling. Do you think this support will ever be integrated? I was quietly hoping that it would be possible already...

Without the support of the calibration file, all measurements are just "cooking water". I have a Samsung Galaxy S10 and at the same time two versions of the measuring microphone Dayton Audio IMM-6 and IMM-6C and both are supported in the application and correctly identified before the...

I tried it on a photo tripod. The microphone stand has a thread from the bottom identical to the camera.