Recent content by noise

It does and works very well!

I set up my Ultra with different per channel PEQ, but now the PEQ Mode option disappeared from the app (I can only select one PEQ at the time). App version: 2.11.5.240906.9aeed4 firmware version: 5.2.627753

Yes of course down sampling everything to 16/44 does work, but that's not the point. I tried different delay values, but with no good results.

I have a SMSL DO100 Pro DAC connected to Wiim Ultra via coax and when I turn max resolution to 24bit 196hz I hear pops and clicks when playing from sources with different resolutions. I feel fixed resolution would help here. Would love Wiim to add it to Ultra via a software update.

@slartibartfast so in the end, what procedure for calibrating two separate channels with a subwoofer did you find most effective?

I also feel that a cleaner solution would be having a dedicated PEQ for subwoofer offered explicitly by wiim devices.

What if you divide the amplitude of peq changes below the crossover for each channel by two?

Two questions: 1. How does this work with the sub in the loop. Lets say my crossover is at 80Hz and I have a PK at 40Hz goin -10db on both left and right channels. Will the subwoofer get -10db or -20db at 40Hz? 2. I see you use a mix of PK and LS. Was this manual or is there and automatic REW...

Would be happy to beta test the upcoming WiiM room correction to see if it works better.

I cannot rule out I messed something up. I did skip sound card calibration. I did measurements and the changes I made on WiiM Amp did impact the measurements. Estimated PEQ parameters made the predicted impact on the frequency spectrum. The thing is that I personally cannot really hear the...

I just finished using REW with calibrated microphone (umik-1) to perform room corrections for my 2.1 system. I was able to figure out relative subwoofer volume, best cross over point and generated 4 PEQ correction to flatten the response. Doing this with the app was super easy - I only wish...

Is it possible to control balance via the API? I would like to adjust it dynamically depending on the sitting position detected via a mmwave sensor.

Version 2

I received a replacement unit today - PCB version 5. The humming noise is completely gone. In addition the power consumption decreased from 15W to 12W (while playing music). Standby is still 4-5W (this was fixed even on PCB version 2 with firmware update). Heat while playing music remains...

Done