12V Trigger Not Changing after firmware release 5.2.634663

Dennis

New member
Joined
Nov 7, 2024
Messages
3
After the latest Firmware release this morning and the 12V trigger function is broken. To prove this, I attached a multimeter to a 3.5mm lead there was no change (near 0V) between On and Standby. I assume others have the same issue? I've just reported this and we'll see what the response from Support is
 
Cannot confirm this behaviour, Trigger works as expected with new Firmware here (Ultra <-> Fosi ZA3)
 
Here also a correct working trigger with the new fw.
Did you try a power off, wait and restart of your ultra?
 
Mine works fine. Send message via wiim app so they can look at your log.
 
Thanks for confirmations all!
Mine works fine. Send message via wiim app so they can look at your log.
Please submit feedback as Smartplug suggests @Dennis so we can check it out! You might want to reseat the cable on both ends as well just in case.
 
Just took the update this morning, which I was hesitant to take as I had already read this thread - No issues with the trigger to my Fosi/SVS.
 
After the latest Firmware release this morning and the 12V trigger function is broken. To prove this, I attached a multimeter to a 3.5mm lead there was no change (near 0V) between On and Standby. I assume others have the same issue? I've just reported this and we'll see what the response from Support is
Hi, thanks for the replies. It could be a coincidence that the trigger stopped working after the update.
 
In the past, this has happened to me as well. Usually I had to reboot everything and then it worked again.
 
Hi All. again, thanks for the responses. After testing the trigger output numerous times it didn't change from near 0V. This was measured with a 3.5mm mono lead (tested), connected to a Fluke Multimeter - I tried rebooting, resetting to factory setting, powering on/off numerous times. So, I've returned the unit to the retailer as faulty. (only three weeks old)
 
Back
Top