Can Pro Plus drive monoblock power amp directly?

[Natman]

I own a Pro Plus and I see it has 10 ohm output impedance @ 2V.
I would like to drive a pair of Dynaco Mk3 monoblocks which have 470k input impedance.
Should I be using a preamp or can the Pro Plus drive them properly without issue (mismatched gain/volume or distortion)?

Thanks!

 

[harkpabst]

I own a Pro Plus and I see it has 10 ohm output impedance @ 2V.
I would like to drive a pair of Dynaco Mk3 monoblocks which have 470k input impedance.
Should I be using a preamp or can the Pro Plus drive them properly without issue (mismatched gain/volume or distortion)?

Thanks!

Yes, the WiiM Pro Plus can easily drive these monoblocks and it can also take care of the volume control. Use good shielded cables.

I don't see any input sensitivity value provided but the WiiM Pro Plus supports a wide range from 200 mV to 2 V rms. In doubt, start with the lowest value and try if you can reach the volume level you need.