WiiM Vibelink Amp Firmware v1.2.714817 Update - May 12, 2025

Please review the WiiM Vibelink Amp update release notes below. If you encounter any issues, feel free to reach out to us. This firmware update is being rolled out in stages, with devices updating sequentially over the next few days.


Release date:

5 / 12 / 2025

What's New:

1. Multiple App Connections: Supports up to two apps connected to the Vibelink Amp simultaneously for control.
2. Faster OTA Updates: Reduced the time required to complete over-the-air (OTA) firmware updates.
3. Standby Improvements: Improved signal detection to reduce false wake-ups from signal fluctuations.
4. Playback Improvement: Fixed brief playback stuttering when powering on in RCA input mode.
5. Quick Sleep Fix: Resolved an issue where the device might switch modes after quickly toggling Sleep ON/OFF from the app.

 

[Wiimer]

Please review the WiiM Vibelink Amp update release notes below. If you encounter any issues, feel free to reach out to us. This firmware update is being rolled out in stages, with devices updating sequentially over the next few days.


Release date:

5 / 12 / 2025

What's New:

1. Multiple App Connections: Supports up to two apps connected to the Vibelink Amp simultaneously for control.
2. Faster OTA Updates: Reduced the time required to complete over-the-air (OTA) firmware updates.
3. Standby Improvements: Improved signal detection to reduce false wake-ups from signal fluctuations.
4. Playback Improvement: Fixed brief playback stuttering when powering on in RCA input mode.
5. Quick Sleep Fix: Resolved an issue where the device might switch modes after quickly toggling Sleep ON/OFF from the app.

I installed this firmware yesterday. And today I was listening to Amazon music on my WiiM Ultra connected to Vibelink for an hour.

When I selected the next album to start playing, there was a pop noise at the beginning of the track. When I tried other albums, I always heard a pop noise at the start of playback.

So I paused the music. Then Vibelink started behaving strangely.

The LED light dims and brightens. It seems to be cycling through standby on/off about every second.

When I touched the top panel of the Vibelink, it felt hotter than usual. I unplugged the Vibelink and switched it on after a while. The Vibelink then returned to normal.

I then played music for an hour and could not reproduce the same problem. I don't know what caused this, but did the heat cause it to run out of control ?

Just to report.
(Sorry, I didn't have WHA and Vibelink connected, so I couldn't send the device logs.)

This is a video of the problem. It's hard to see, but the LEDs are flashing by themselves.


View attachment 1000000145.mp4