Recent content by Starsick

I KNOW I am a bit naive in the networking world - I just seem to be stumped (mentally) why I can access the LMS Server from a wireless network and manipulate the web GUI no problem, but why I cannot get the LMS to find my player that is on a wireless network confounds me. As mentioned earlier...

Yes, no problem at all.

I understand. I can open a command line and ping from wired .111 to wireless .100 no problem with any device on the wireless networks, so at least I know that is correct. The WiiM will do me not good down where the switch is, of course. I am going to try to figure this out - at least I know that...

Also, I have plugged into my wired ethernet switch and LMS found the WiiM Pro. However, This device normally resides upstairs on my third floor in a designated spot in my recording studio, with a dedicated sound system. How will I be able to communicate - or have the LMS find - the WiiM player...

My original thoughts on all of it was to split the load from my high speed connections - on wireless subnet is for Alexa's, Phones, and the other is for Streaming video and security video systems. The wired is simply my Video editing workstation, some security devices and the plug ethernet is...

I see. I have done both for my pihole and other devices, is this a bad practice (Reserve IP and Static IP set)?

Again, thank you so much. I have set the internal static IP for the piCoreplayer, and have set a reserved IP in DHCP in my router for the Pi. In the other threads and on other forums, you have guided me and helped solve the SD card issues, I am grateful. Thank you. As to "players" when I test...

I have set up an LMS server, and from what I understand in my reading in this forum, that I would be able to stream music from the LMS server to the WiiM Pro. However, when I tried to do so, I'm unable to get any audio. In a similar setup with my router, my Cambridge audio server works with...

Understand. Thank you for all of your help....I have NOT tried playing the LMS over the WiiM as of yet, but if I understand you correctly, I should just be able to fore up the LMS on my tablet (on my wireless network) and go, right? That is how the Cambridge is (it is on the same net ip range as...

Understand. NP. I am relocating the LMS prefs and cache to a 32 Gb SD card I had laying around, mounted on a USB adapter. It appears my problems were the cache folder was full. I relocated the data to the SD Card, it is currently rescanning the library. W: Should I still expand the card since I...

I have a 512 GB card in the LMS, and when I originally set up the unit, opted for 2000MB instead of whole card (it had a danger warning). It appears I have run out of space, should I resize to whole card? I looked at the log files and found out why the scan was terminating - due to no disk...

Thank you. I have tried restarting the scan several times and it never gets past the first bit. It just terminates, should I increase network wait time in LMS? Also, I have not done this, should I also enable Wifi for LMS as well, I have it in my wired network and I assume that will always be...

Quick Question - I have a LOT of songs and albums....I noticed the scanning quit abruptly, and that the "building index" and "artwork" SEEMS to be stuck - or is taking a LOOOOONG time. Is this normal? The connection to the share is slow, as it is ethernet over electric lines. (about 2 MB per...

UPDATE: I unchecked the first share entry that I had been editing, checked the second one and entered identical credentials as above, added vers=1.0 to the options field.....and BINGO! The drive is now mounted, is scanning content as I write this. I cannot thank you enough for your help, and...

I am not well-versed in that - what would the command be?