subwoofer

  1. M

    Subwoofer output at low volume intermittent. Gate / Threshold?

    This is something I notice a lot when listening to podcasts at low volume, the subwoofer output intermittently cuts in and out, in response to the volume level of the voice. It behaves similarly to an audio gate, where the signal is only played when above a certain threshold. I use a high...
  2. C

    Sub options

    Hi all, I'm new to Wiim and so far I'm impressed with my Wiim streaming amp which I have connected to a pair of Monitor Audio C180 ceiling speakers. I'm now wanting to add a bass speaker. I already had a Bose 500 bass module but I cannot get this to work either wirelessly or hard wired to the...
  3. D

    The General Subwoofer Thread

    Rather than hijack the other subwoofer thread (more than I already have), I figured it might be fun to start another one that goes into more detail on how folks are using subs instead of just what subs they’re using. There are some folks in there who have some very interesting setups, in...
  4. motleypixel

    Sub Calibration 13ms delay vs 0ms...

    I’m running my Ultra RCA out to a class D amp. This amp has tone controls set to noon aka flat and volume at about 90%. Out of the Ultra I use LFE to my active subwoofer (Definitive Technology Super Cube II). I leave “Fixed Volume Output” off to allow the Ultra to control my volume. When the...
  5. Wingos

    WiiM Amp Pro doesn't turn on subwoofer in auto mode (B&W ASW610)

    Hello, When I turn my Wiim Amp Pro on and play music with the Bowers & Wilkins ASW610 connected by an RCA cable (thru "Sub out" port) on "auto" it doesn't turn on. If I put the subwoofer on "On" it works fine. I tried running a subwoofer test and this test after a first fail did turn the...
  6. Krabin

    Measurements of the EQ Filters - How to know exactly what the PK, LS, HS, LP, HP, and Sub Crossover are doing

    I tooks some measurements using REW to see what exactly each EQ filter is doing in the WIIM Ultra (very likely also applies to the other WIIM devices with PEQ): https://drive.google.com/drive/folders/1dn8LXOGKAgZzBwcPt8xlftjE9Lp3DDK7 (google drive link, let me know if it doesn't work) The "App"...
  7. S

    Subwoofer Output Keeps Turning Off

    I have a recurring issue where the subwoofer output on my Wiim Ultra switches itself off. I'm not sure if this issue originates in the Wiim Ultra itself or the iOS app, but both are up-to-date. I'll repeatedly set the toggle switch for "Sub Output" in the Subwoofer menu to "on," then notice a...
  8. Andrew78

    Wiim Amp Ultra - Polk Audio XT20 & SVS SB 1000 Pro - Configuration

    Hi everyone, I'm new to the Wiim world! :) I recently purchased a Wiim Amp Ultra in combination with Polk XT20 speakers and I have to say I'm very happy! ;) To complete my system yesterday I purchased a SVS SB 1000 Pro Subwoofer. The Sub will be connected via the Sub Out output and LFE input...
  9. A

    Wiim Ultra subwoofer LFE question

    I tried searching the forums but can't find a definitive answer so figured I asked her just be safe. I just upgraded from the Wiim Pro Plus to the Wiim Ultra. Mostly because of the subwoofer out. I used to have my BK XLS200 high level to my amplifier. Now I'm using low lefel to the mono (lfe)...
  10. Atlas B170

    Room Correction with Subwoofer crossover?

    Hi, I've got a setup with an Amp, a pair of bookshelf speakers and a powered sub. Currently, I have the crossover frequency set to 100 Hz. When running room correction, should I set the frequency range to start at 20 Hz, or at the crossover frequency of 100 Hz? Initially I thought to run it from...
  11. N

    Presets and sub settings

    Hi, I have an Ultra with the latest firmware (5.2.719248) and WHA (3.2.3) Background settings are: Input = Optical; Output = Line out; EQ=Off; Room Correction =Off; Subwoofer = On; Sub crossover = 90Hz; Sub bypass = Off; Mains full = Off. I created Preset A with these settings. Then created a...
  12. L

    Volume subwoofer in Wiim Ultra and Vibelink Amp

    Hi friends. I have a Wi-Fi Ultra connected to a Vibelink Amp and Kef LS50 Meta speakers. I've installed a BW ASW610 subwoofer, but I'm still not sure how the setup works. I hope you can help. The subwoofer is connected to the Ultra's sub-out and from there to the subwoofer's LFE input. I have...
  13. H

    Subwoofer for Amp Pro

    Hi everyone, I've just bought a Wiim Amp Pro and have a pair of Q Acoustics 3020 speakers attached. I'd like to get a subwoofer to complement them. I have browsed the forums, but can't find anything in the UK so far. I've found the Q Acoustics 3060s on Richer Sounds for £249 and wondered if this...
  14. EddNog

    Hypothetical Setup Question

    Would it be possible to use two WiiMs together to set up a full 2.2 setup? For example, WiiM Ultra as main, "head unit," hooked up to main loudspeakers, with bass management turned on and high-pass crossover turned on to the main loudspeakers, nothing attached to the subwoofer LFE output. Then...
  15. W

    Is it possible to use PEQ on each channel when using Dolby 5.1?

    I am currently using wiim amp. I would like to know if I can purchase wiim amp pro and use it as shown above. My main question is as follows. 1. Is it possible to use PEQ in each channel(4channel)? 2. Does the crossover apply to all channels? 3. Is it possible to output to the surfwoofer from...
  16. W

    subsonic filter support

    I'm going to buy a passive subwoofer. I want to use this subwoofer with an inexpensive power amplifier. So I need a subsonic filter. It's good to support a subsonic filter on the subwoofer channel. Another way is to support independent PEQ on subwoofer channels.
  17. RyanWithWiiM

    Introducing WiiM Sub Pro: Experience Bass Like Never Before

    🔥 WiiM expands into deeper sound! Meet WiiM Sub Pro, our first-ever subwoofer, designed from the ground up to deliver deep, distortion-free bass with AI-driven precision. Whether tuning your music, movies, or gaming setup, this sleek sub delivers precision through its 8-inch driver and Class-D...
  18. T

    WIIM Ultra sub output problem

    Hello, I've encountered a problem where the sub output on my WIIM Ultra sub output problemexperienced this issue before? When connected to an active speaker or another player's sub output, the subwoofer works fine. I've tried replacing the cable and restoring factory settings, but nothing has...
  19. S

    Subwoofer not found

    Hello; I am a new user of the ultra. I have music playing fine into my amp using rca output. I connected my infinity brand powered subwoofer and it is not found by the Ultra. The Infinity subwoofer works fine on my pioneer amp. I tried a different RCA cable to no avail. I find no subwoofer...
  20. R

    Sub and pre-gain settings: peak hold VU meter wanted

    I know this is an oldish thread, but this message is in context here. I've got 2 Speedwoofer 12s, with wiim ultra crossover set at 90hz, that I stand my stock-standard Yamaha ns-1000m on. Setting these active subwoofers to maximum volume allows me to set subwoofer level in wiim to -15db. Room...
Back
Top