Newbie question - Set up a default state when using multiple Wiim products?

[SD858]

Hello,

I have a couple Wiim Amp Pros, a couple wiim pro Plus and one wiim Ultra setup. Some are inside my house and some outside zones.

When I I run different groups everything works as it should. However, my TV is connected to one of the wiim amp Pros running my sub and l/r channels.

If I've been using a group but everything is turned off and my kids turn on the TV, sound comes out through whatever group I was running and obviously, the lipsync is off and noticeable.

Is there a way to have the system default to only the wiim AMP pro when the TV turns on? My kids are 8 and 11 and they don't have a device so there's no way for them to turn off the groups if I'm not home. It would be great if I could figure out a way to single out the AMP pro to only play the TV volume and not play throughout the whole house group without going to the app to change it.

Thanks for any help! Travis

 

[Burnside]

I guess you might need to wait for the next version of smart presets which should allow the selection of a persistent group or a single device. I’d drop a line to WiiM via the more/feedback section of the app asking them when this enhancement might be available and whether it would resolve your problem.