Sample rate switch latency
- Thread starter Bismarck
- Start date
Where do you see that setting?
It seems to delay turning on the output after it has been turned off because of sample rate change or manual advance to the another song.
But why is it turned of because of sample rate change or manual advance to another song?
Is it necessary.
WHA device setting audio output
Thanks, found it.
MrSoul4470
Active member
Huh? I thought it delays turning OFF the output at track changes? Well, I thought it's at least supposed to, because it doesn't seem to do that.
I think it's necessary when sample rate changes to let know the DAC that spdif clock must be locked and synced again. In case of just a manual advance it's not necessary. In fact it doesn't happen with Tidal Connect or Spotify.
I've seen a delay between "off" and "on" states when I was testing this behavior.
MrSoul4470
Active member
Really? I played with it a bit but didn't notice ANY difference.
My DAC also shows that the signal is gone right away after skipping to the next track. No delay. A one second delay should be quite obvious. I thought that was exactly what it's supposed to prevent. But maybe I just don't understand this feature.
View attachment 3.mp4
Difference is quite significant I would say.
Difference is quite significant I would say.
Why setting such a delay should avoid popping/clicking?
Similar threads
- Question
