Wiim Pro Plus not working - solid Green Light for 10 sec then no light for 3 seconds.

[Imeasure]

Wiim Pro Plus not working - I get a solid Green Light for 10 sec then no light for 3 seconds and it repeats.

Can't connect to it.

Any ideas appreciated.

I have had this unit running for over 6 months.

 

[Wiimer]

Wiim Pro Plus not working - I get a solid Green Light for 10 sec then no light for 3 seconds and it repeats.

Can't connect to it.

Any ideas appreciated.

I have had this unit running for over 6 months.

Does the WiiM app show Pro Plus?

The green LED may be due to Bluetooth. Check that there is no Bluetooth connection between the phone and the Pro Plus.

Also, unplug the device's power cable, connect it after a short while and reboot.

 

[Mr Ee]

Welcome.

What have you tried so far?
Wifi? Ethernet?
Remove the power for 1 minute.

 

[Imeasure]

I figured out the problem, I had a high powered USB adapter that I use to fast charge my phone pluged into it. Plugged in the supplied lightweight usb adapter and it's running again.

 

[harkpabst]

Have you been using this "high powered USB adapter" throughout this six months plus period?

If so, I wouldn't have much trust in it for any application.

 

[Imeasure]

Have you been using this "high powered USB adapter" throughout this six months plus period?

If so, I wouldn't have much trust in it for any application.

No I just connected it by mistake this one time.

 

[harkpabst]

No I just connected it by mistake this one time.

In this case the USB adapter is probably OK.

The SMPS USB power supplies do actively monitor ins adjust the output voltage to be 5 V exactly. It's in (relatively) very low load situations where the control loop might not work as expected and cause voltage drops and spikes.