It should work if you connect to either port.But I only need one subwoofer, so which port should I connect it to.
New Roadmap
- Thread starter Wiimer
- Start date
-
- Tags
- wiim ultra
DariuszP
Active member
Looks like a lot, but unfortunately the two features that I am most interested in (and actually - already confirmed by WiiM as “coming soon” quite a while ago) are missing on the list, being:
a) more presets (like, say: 32 - and access to more then 8 of them from the remote), without it usability of presets is quite limited in my setup (4 favorite radio stations and 2 favorite outputs leave me with only two “free” presets to use for adding e.g. favorite records or playlists).
b) ability to assign room correction to each of the outputs (or: as WiiM suggested - to particular presets) - without it the entire room correction makes very little sense in my setup (Ultra connected to two amps / speaker sets used alternatively - before switching output I must always remember to dig (deep!) into the menus to change room correction into the right one).
I recollect that “more presets” was a quite popular demand among user base and adding the ability to link RC profile to output could not be THAT difficult, thus those omissions make me very disappointed.
EDIT: It seems item 2) is being taken care of - just did not notice this while reviewing the list:
a) more presets (like, say: 32 - and access to more then 8 of them from the remote), without it usability of presets is quite limited in my setup (4 favorite radio stations and 2 favorite outputs leave me with only two “free” presets to use for adding e.g. favorite records or playlists).
b) ability to assign room correction to each of the outputs (or: as WiiM suggested - to particular presets) - without it the entire room correction makes very little sense in my setup (Ultra connected to two amps / speaker sets used alternatively - before switching output I must always remember to dig (deep!) into the menus to change room correction into the right one).
I recollect that “more presets” was a quite popular demand among user base and adding the ability to link RC profile to output could not be THAT difficult, thus those omissions make me very disappointed.
EDIT: It seems item 2) is being taken care of - just did not notice this while reviewing the list:
- Advanced Profile Management: Transfer correction data across devices, map "RoomFit" to specific presets, and utilize Expert Mode for weighted measurements and deeper analysis.
Last edited:
Use one for Mondays-Thursdays and then swap to the other for Fridays-Sundays.But I only need one subwoofer, so which port should I connect it to.
Similar threads
- Featured
- Article
