I am also waiting for a timeslot to rerun my roomfit when family is away. I got some suggestions that were kindly shared by one of the experts.As the wife is out today I thought would start playing around with Roomfit
My setup details are in my signature.. Room is 5m x 4mI am also waiting for a timeslot to rerun my roomfit when family is away. I got some suggestions that were kindly shared by one of the experts.
I don't know enough so will wait for the experts to comment on this thread. It may help if you share your setup details i think. I guess +/- 3db differences from the target isn't bad in general based on my understanding, hope wiim will show what's a reasonable margin in the graph some day.
Thank you, I’m using a Umik-1It looks promising!
The phone's built-in microphone might not be picking up the subwoofer's low frequencies, but there don't seem to be any major peaks or dips. As is often recommended, I suggest setting the frequency range to 20Hz-300Hz and trying a moving microphone measurement.
I’ve re run based on your suggestions..
For some reason signatures don't appear when viewing the forum on a phone.My setup details are in my signature.. Room is 5m x 4m
AhFor some reason signatures don't appear when viewing the forum on a phone.
What does the response before correction look like? What is the sub crossover. There is a deep dip at 50 Hz.Ah
Setup :- Wiim Ultra > NAD C388
Speakers :- Dali Oberon 5
Subwoofer :- B&K P10-150-Gem (Red)
Try turning your phone so it is in landscape mode, and then you should be able to see signatures.For some reason signatures don't appear when viewing the forum on a phone.
That looks pretty good to me. Good job!And my final attempt today![]()
I'd be very tempted to keep the proposed correction below 500Hz... but keep the original above... In any case, the two options could be compared without preconceptions by listening... to decide...And my final attempt today![]()