You set up the crossover frequency, the sub level and the required delay manually. Room correction doesn't tackle these settings.
How to use Room Correction?
- Thread starter MCG555
- Start date
Interestingly, that isn't the orientation featured in the WiiM Home iOS Room Correction FAQ, but rather
WiiM may have great engineers, but they could use a little help on the Technical Writing / Artist side.
True. There are a couple of discrepancies in this regard. It is also written that it does not work with Subs. It works perfectly…
Theres actually a very important point wiim left out in the guide. There a feature. in the iphone for the “mic mode” (accessible in the control center while speaker on, on a call). Theres 3 settings. Voice isolation, normal and wide spectrum.
Since release the wiim room correction didn’t work for me. Collapsed everything into speaker sound like a small Bluetooth speaker. it was because I had voice isolation on the mic mode (because I prefer it on phone calls filters out the background noise.) Once I turn to normal everything in room correction started working. I wonder if wide spectrum would yield better results even or same problems
Since release the wiim room correction didn’t work for me. Collapsed everything into speaker sound like a small Bluetooth speaker. it was because I had voice isolation on the mic mode (because I prefer it on phone calls filters out the background noise.) Once I turn to normal everything in room correction started working. I wonder if wide spectrum would yield better results even or same problems
ArthurStereo
Active member
- Joined
- Jun 21, 2024
- Messages
- 113
You're right, it's important. I didn't pay attention to that. Wiim should determine that and write that information in the application in the RC section.
slartibartfast
Major Contributor
- Joined
- Apr 18, 2024
- Messages
- 1,839
If the setting is only available while the speaker is on during a call it seems odd that the same setting would be used for anything else using the microphone.
Its available anytime the microphone is on in speaker mode. When chosen it defaults to that same setting every-time unless changed.
Attachments
slartibartfast
Major Contributor
- Joined
- Apr 18, 2024
- Messages
- 1,839
Good find then. I was looking for that kind of settings on Android but didn't find anything. Do they say what Wide Spectrum means?
And one more time here:
www.lifewire.com
Wide spectrum sounds like a bad idea for measurements, too.
Wide Spectrum on iOS 15: What It Is and How to Use It
Here's how to use Wide Spectrum mode on FaceTime to enhance background noise so your friends, family, or colleagues get better quality.
Wide spectrum sounds like a bad idea for measurements, too.
I don’t have a “mic mode” in my Control Center.
Once you have a phone call or using the mic itll show up.
Might not be available on all models supported by the WiiM Home App. I can't find it on an iPhone 11.
ArthurStereo
Active member
- Joined
- Jun 21, 2024
- Messages
- 113
Voice isolation is available from iPhone XR and iOS 16.4. It's hard to find. You can only enable it during a call and you have to expand the Control Center.
ArthurStereo
Active member
- Joined
- Jun 21, 2024
- Messages
- 113
It doesn't work on the recorder. It's best to call someone.
No the bottom
Of course it is the one at the bottom, but you have to point it towards the loudspeakers - so - front!
Kblade97
Member
- Joined
- Dec 14, 2023
- Messages
- 47
Not to crash the party but I would think you need to be careful adding gain it 31 Hz at 6Db and then again at 72 Hz and 110, 534 Hz. Are your woofer’s jumping out of the cabinets? I would just be very careful not to hurt your speakers. It did take away 9Db at 56hz but still, I would be careful of boosting as opposed extracting bass. Obviously it’s sounding more bass heavy. Is it actually better? Or just different. Is it straining the speakers any at all, and taking away loudness. Obviously you know more because it’s your room, but I would just be careful.
